In a message dated 9/15/00 5:56:08 AM EST, [email protected] writes: << Real world needs require that current density to be high enough to drive an acceptable rate of ions into solution, but only to the point where this does not interfere with the hydration and dispersion of the ions throughout the solvent, before they aggregate into large particles. The only way to drive this current is to raise the voltage so that an initial current is achieved, and then to lower it progressively as the conductivity of the water increases, to maintain a current judged to be optimum. In this manner it is possible to construct a colloid which is as I said before is made of a loose association of silver ions. >>
Ivan: How does one judge that the initial current is too low or too high? I have the same question when it comes to lowering the current when the conductivity of the water increases over time. Roger -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
