I have found that fresh ozonated DW makes for heavier oxide deposits than if the water is heated or just left loosly capped for a few days. In either case most of the dissolved gasses form bubbles on the sides of the container and dissipate into the air. Ken
At 02:33 PM 10/22/00 -0500, you wrote: >Hi Ya'all, > >I had mentioned on an earlier post that a friend of mine, Curt, is the >chief chemist for a national supplier of chemicals to the baking >industry had said that ALL DW must by law be ozonated. > >He recently purchased a "modulated CS gen." (constant current) and ran a >16 oz of DW that has a conductance of 0.22 uS., for 6 hours and it >turned muddy. He then did a rolling boil of the DW for three minutes (if >you use a microwave let it cool for about 5 min. before opening door) He >covered the container with plastic wrap and put in the frig. until abut >70 deg. He repeated the run and obtained clear 22 ppm CS with a solid >T.E. He is now working to reduce the T.E. > >The instructions said that he should have 20 ppm and I measured it for >him with my spect. and it was 22 ppm. > >I am trying boiled water in my HVAC arc to check for reduction in NO3. >Will advise when finished. > >"Ole Bob" > > >-- >The silver-list is a moderated forum for discussion of colloidal silver. > >To join or quit silver-list or silver-digest send an e-mail message to: >[email protected] -or- [email protected] >with the word subscribe or unsubscribe in the SUBJECT line. > >To post, address your message to: [email protected] >Silver-list archive: http://escribe.com/health/thesilverlist/index.html >List maintainer: Mike Devour <[email protected]> > > Tired of buying questionable qaulity colloidal silver at high health food store prices? Make your own high quality Colloidal Silver at home with this automatic process, current controlled colloidal silver generator. http://www.silverpuppy.com
