Congrats.  BTW, I doubt if your rig will work for long: I recommended
galvanized steel backing plates because copper corrodes quickly--esp. in
a saline environment (as beach dwellers will affirm)--and copper oxide
(the green patina you've seen on old pennies) is non-conductive.  --Russ

On Thu, 16 Nov 2000 01:26:58 EST [email protected] writes:
> Russ, thank you for the further explanation.  
> 
> In repeating the process (and explicitly following your example), it 
> works 
> flawlessly.  No Bite from the 9V.  The sponge was just slightly damp 
> with a 
> very mild salt water solution.  Tried the process first from several 
> 
> positions on the right hand, and then also again on the left hand.  
> No bite.  
> 
> This was a single 9v, clip connector (5 in a package from Radio 
> Shack).  The 
> wires are 5 3/4 inches long, with a small wire nut attaching to a 
> longer set 
> of wires (12 inches).  The longer wires were taped to two pieces of 
> copper 
> (2x3 inches).  Sponges glued to the copper.  The handles were two 
> small 
> pieces of wood that hubby glued to the top of the copper pads.  
> 
> Will repeat the process tomorrow, and if the same results are 
> obtained, will 
> add one more 9v battery, and repeat the process with two batteries. 
> 
> Thank you so much for your detailed insight.  suzy
> 
>        


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>