http://home.att.net/~ralph.hartwell/wavshap2/wavshap2.htm
A waveshaper that ensures a good square wave even from a sine wave. And an updated rife freq generator program that will use the sound card OR the built-in speaker of your computer. Date: Sun, 27 May 2001 17:09:44 -0400 From: "Fred Walter" <[email protected]> Subject: freqgen 1.02 (use your PC as a frequency generator) I've uploaded Version 1.02 of freqgen to: http://groups.yahoo.com/group/rifers/files freqgen turns your PC into a frequency generator under Windows 95/98/ME/NT/XP. If there is a sound card present in your PC then freqgen uses it, otherwise freqgen uses your PC's internal speaker. Your PC, with freqgen and the hardware to turn the signal from your soundcard into the right waveform/voltage, can be used either to drive a Bare/Rife device, or as a pad/contact frequency device. I'm making the software freely available because I want someone who knows electronics to design the above mentioned hardware and to make this design freely available. As an example, if you want to run all the frequencies associated with parasites then you would do something like the following: freqgen -f data/parasites* When extracting the contents of the .zip file you should maintain the directory structure. For example: pkzip -extract -directory=current freqgen1_02.zip where pkzip is shareware program downloadable from http://www.pkware.com freqgen can be used in one of the three following ways: freqgen [X] -f frequency_file [frequency_file [...]] or freqgen [X] -s sweep_start,sweep_end,sweep_increment[,sweep_duration] or freqgen [X] frequency[,duration] [frequency[,duration] [...]] where [X] is: [[-b bracket] ...] [[-o offset] ...] [-i] [-v volume] [-V] Options: "-b bracket" outputs the specified frequencies by "+/-bracket" NOTE: this option can be repeated many times NOTE: a "bracket" of 0 means output the specified frequencies "-o offset" outputs the specified frequencies by "+offset" NOTE: "offset" can be negative NOTE: this option can be repeated many times NOTE: a "offset" of 0 means output the specified frequencies "-i" forces freqgen to use the internal speaker; default behaviour is to use a sound card if one is present "-v volume" sets the volume if the sound card is used; possible values range from 0.0 (off) to 1.0 (full); default value is 0.5 "-V" prints version information default behaviour is to use a sound card if one is present The "-o offset" and "-b bracket" options were added because of the following information found in the "Consumer Guide To Rife Generators": :In any pure culture there are always mutant strains, :typically about 20% of the microbes present. :These do not respond to the center frequency, :but to a frequency of 1 to 2 hertz off the center. NOTE: only frequencies in the range 37-32767 are supported NOTE: if a duration is "X" seconds then the associated frequency will run for at least "X" seconds and no more than "X+1" seconds NOTE: all durations are optional; if omitted then the default duration of 180 seconds is used --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.252 / Virus Database: 125 - Release Date: 5/9/01 -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
