As with anything there is a right way and a wrong way to do anything. Submerged
electrodes work great, that is what I use. But you can't just put them in the
water, too much surface area, you will get almost no voltage.  Instead you have
to put them in pyrex tubes so that only about 1/10 inch is exposed well below
the surface, and the voltage must be monitored and the exposed electrode length
varied so that you maintain between 9,000 and 11,000 volts for the entire run.

This yields 5 ppm crystal clear CS with 20% particle and 80% ionic content.

Marshall

Robert Berger wrote:

> Ken,
>
> Evidenly your HVAC generator has both electrode  well immersed in the DW.
> Been there and done that! That process is JUNK.  I diwscarded that process
> two years ago.
>
> "Ole Bob:
>
> ----- Original Message -----
> From: "Ode Coyote" <[email protected]>
> To: <[email protected]>
> Sent: Thursday, September 20, 2001 6:58 PM
> Subject: Re: CS>AC or DC, that is the question.
>
> >   There is ore than one type of DC generator and more than one type of AC
> > generator as well.  I have an HVAC generator that makes black brown mud in
> > less than 4 minutes and DC generators that make an apparently fine product
> > at 20+ PPM in about 2 hours.
> > Ken
> >
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> To join or quit silver-list or silver-digest send an e-mail message to:
> [email protected]  -or-  [email protected]
> with the word subscribe or unsubscribe in the SUBJECT line.
>
> To post, address your message to: [email protected]
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
> List maintainer: Mike Devour <[email protected]>