Evening Wayne,
>>I purchased a 6 volt 300 mili amp. ac/dc power source. First question
Should I get some type of reducer to bring the milliamps down to around 6-8
as I read was a optimal rating for brewing CS. Does it matter if the 300 ma
is reduced?
The 300 ma is the max current that the power source should deliver. It
has no bearing whatsoever on
the current draw of your process or load.
Next questions if I do reduce to 6-8ma ............
The conductivity of your solution will determine the current, nothing
else. If you don't have a current meter, you
will likely never know what is actually happening.
Don't worry about reducing it. Worry more about exceeding an acceptable
limit for your process.
what would be an estimated brewing time for CS using a aquarium air pump
to force air and circulate while
brewing. Say about a quart of water at a time.
Six volts will take a while. I would suggest 18, 36 or more. Of course
the six will work but slowly.
If it is OK to use the 300 ma what would be the brewing time?
I would guess, 1.5 to 3.0 hours but other factors enter in. Are your
going to use saline or CS to increase the
conductivity or your distiller water? If you don't plan on taking a good
long nap while it is brewing.
Wayne
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
