Hi Robert, This is amazing! The strongest cs I have ever made is still clear!
After several hours it seems to have turned the slightest shade of straw, but then it stopped. If you hold it up to the light, it is crystal clear. There is no sign of plate-out whatsoever. The key seems to use large surface area rods, run at very low current and applied voltage, and brew for a long time. This is a tremendous breakthrough for me. I have never seen results this good. Thank you for posting your information on clear cs! The previous ULVDC batch made with thermal stirring is still crystal clear. According to the salt test, it is about the same strength as I normally make, and it would have turned yellow and started plating out by now. I started a new run using the standard two rod setup. It has a 51k in series with a 9V battery for a current of around 120uA. The wetted area is 0.9 sq. inch, which gives about 133 uA / sq. in. The electrode voltage started at 2.5V and is just passing 2.0V after 3hrs. The voltage is a bit higher than I would like and it is decreasing much slower than I wanted. Unfortunately, the glass is quite a bit larger than I wanted but it was the only thing that would fit the lid. But this will be a good test to see how close to the ionization potential of water affects the result. Thanks for pointing that out, I had not picked it up searching the archives. More news later... Best Regards, Mike Monett -- The silver-list is a moderated forum for discussion of colloidal silver. Instructions for unsubscribing may be found at: http://silverlist.org To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
