--- Ivan Anderson <[email protected]> wrote: > It is my understanding that the normal cold corona > ozone generating > machines will only produce nitrous oxide when fed > with moist air. > Ozone produced for medical purposes (including > dental caries > treatment) should be fed with dry air, either by > passing the air > through moisture absorbing crystals or by heating > it. > > Ivan I have now modified the Ellis Ozone process so that it has a gravity feed of distilled water. Ellis process does not use an arc to create ozone, instead it uses a "ozone" quartz bulb in the distillation process where the steam is ozonatated upon condensation. The advantages of using this water for CS production is that is distilled "twice" before going through the CS process. The improvement of Wallmart distilled water after second distillation is that it registers about 12 % less conductive than the original DW. I dont see any problem with using ozonated distilled as a source of CS production, in fact it should be a better product. For those that cannot fathom what they call my "rambling", about my CS process, which is current limited by tank resonance, let me add the following fact: as the CS solution becomes more conductive less current is drawn from the source. In fact more DC current is across the cells, then the AC current that goes in. I have only substituted a rectification process for DC in the middle of a process that normally is only AC, and that is a tank resonance, which has the property of resonant rise of amperage: meaning more amperage exists inside the circuit then is actually inputed. Tonight I staterted a single cell with this water. It initially is DC current limited to 1.08 ma across the cell and reads 1.04 ma @ 18 volts on startup. Tommorow about 12 hours later it will read only 2 to 3 volts across the cell, at a value close to 1.08 ma. The voltage in such a system constantly lowers itself so that whatever the initial setting of current limiting is chosen by variac, it can never exceed that value, because it is "cuurent limited" by the impedance of the outside components on either side of the cell. A schematic of the "binary" resonance circuit that delivers both voltage rise and current rise: depending on the resistance of the midpoint load is at; Binary Resonant Tank Schematic http://groups.yahoo.com/group/teslafy/files/BRS/BRT.jpg
The GREAT expenses here are that large induction coils, employing some 40,000 ohms impedance are on either side of the CS cell, but with capacities having identical impedances in series, this serves to regulate the voltage in such a way as to continually lower it to the lowest possible value that the C.L. setting will provide. Sincerely HDN ===== Tesla Research Group; Pioneering the Applications of Interphasal Resonances http://groups.yahoo.com/group/teslafy/ __________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com -- The silver-list is a moderated forum for discussion of colloidal silver. Instructions for unsubscribing may be found at: http://silverlist.org To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
