url: http://escribe.com/health/thesilverlist/m60210.html Re: CS>Sludge on LVDC Electrodes From: Mike Monett Date: Sat, 14 Jun 2003 14:02:30 I wrote:
3. Put a mark on the outside of the glass to show the fill point. Ideally, it should be above the middle loop of the "W", but you have to leave enough room so the water doesn't hit the top when it sloshes while moving. Looking more carefully at your setup, I see you have a natural fill point at the first thread of the jar. This looks like a good spot. Meaure the quantity of water needed to reach this point. Later, you can use it for Coulomb calculations to estimate the ppm. Then you won't need the Hanna PWT, which is expensive, and can reply on timing the run. Once you get the system set up, you will find it very repeatable. Best Regards, Mike Monett -- The silver-list is a moderated forum for discussion of colloidal silver. Instructions for unsubscribing may be found at: http://silverlist.org To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
