Paul: How much time is required to make what PPM and how much is being produced in this time ? Bill Amos -------------------------------------------------------------- He says, I quote:
>I use the Hanna TDS1 and my DW always measures 1 when I start. >Also, >in California DW is required by law to be no higher in total >dissolved >solids than 1.5PPM So it's very likely that my meter is reading >close >enough. So perhaps you are correct. I'll suggest that to him. Thanks, Paul H ----- Original Message ----- From: "sol" <[email protected]> To: <[email protected]> Sent: Sunday, November 21, 2004 3:23 PM Subject: Re: CS>High altitude CS > What exactly is his uS reading on the distilled water? I'm not > that high, only 6100 ft, but had the same problem, it was the > distilled water, here, it has to be no more than .4uS to > reliably make clear CS. > sol > > Paul Holloway wrote: > >> Hello List, >> I have a friend who lives at 8000 feet altitude. >> He is having problems making CS that doesn't go yellow. >> His water quality is good, as is his technique, from what he >> describes (cold DW 30v limited to <1mA with stirrer or >> bubbler). >> He has concluded that the high altitude is the problem. >> I can't see how that would stop him from making good quality >> CS. >> Any ideas? >> Paul H > > > -- > The Silver List is a moderated forum for discussing Colloidal > Silver. > > Instructions for unsubscribing are posted at: > http://silverlist.org > > To post, address your message to: [email protected] > Silver List archive: > http://escribe.com/health/thesilverlist/index.html > > Address Off-Topic messages to: [email protected] > OT Archive: > http://escribe.com/health/silverofftopiclist/index.html > > List maintainer: Mike Devour <[email protected]> >
