Hi there Ode - I have calabrating fluid which came with the meter from Hanna It is HI 7033 - Conductivity Calibration Solution 84uS/cm @ 25 Degrees C/77 De- grees F. then on the side there is a table which gives temp readings to calibration readout, when I put a thermometer in which reads 23 C or 73.4 F her calibrated reading is 80.2 when it should be 81.0 so it is off very slightly and not enough for me to take out the screwdriver and change it !! Laziness is a terrible disease !!!!! so when I make my C.S. I cut the reading in half to get my ppm which appears to be good brew as it certainly works !!!! so with this imformation and your expert- ese am I reading and calculating correctly, cause if not then my brew is even better than I thought !!!! whichever way it certainly is amazing !!! Best regards Sandee
"The one who accomplished it is the one who failed to realize that he could not do it." -- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Silver List archive: http://escribe.com/health/thesilverlist/index.html Address Off-Topic messages to: [email protected] OT Archive: http://escribe.com/health/silverofftopiclist/index.html List maintainer: Mike Devour <[email protected]>
