On Wed, 12 Feb 2014, Jordi Guillaumes i Pons wrote:
Hello,
After (finally!) networking TOPS-10 running on simh using the KDP/DUP siumlator
I'm trying to do the same with TOPS-20. I have built a TOPS-20 system and I'm
now trying to get DECNET (phase III) running on it. I have followed the
instructions contained here:
http://bitsavers.informatik.uni-stuttgart.de/pdf/dec/pdp10/TOPS20/DECnet-20/AA-5091B-TM_TOPS-20_DECnet-20_Programmers_Guide_Jan80.pdf
and used this tape:
http://bitsavers.informatik.uni-stuttgart.de/bits/DEC/pdp10/magtape/dec_distribs/decnet/DECNET-20_V2.1_2020_7-20-82.tap.gz
but I can't put it to work (NETCON complains about being unable to get the
network topology and FAL dies because an illegal instruction error). Since I
seem to remember someone was succesfull networking TOPS-20 over simh, I'd like
to know if I'm using the correct software kit, or if there is something not
documented to do to put this to work.
Are you going to make a blog post about your TOPS-10 networking journey?
Jordi Guillaumes i Pons
[email protected]
HECnet: BITXOV::JGUILLAUMES
_______________________________________________
Simh mailing list
[email protected]
http://mailman.trailing-edge.com/mailman/listinfo/simh
--
Cory Smelosky
http://gewt.net Personal stuff
http://gimme-sympathy.org Projects
_______________________________________________
Simh mailing list
[email protected]
http://mailman.trailing-edge.com/mailman/listinfo/simh
