Silly question, but you did follow the instructions in the Guide specifically for *2020*, correct? The installation for the Model B machines differs a little from the 2020. I'm a little suspicious that FAL is throwing illegal instruction errors...
-Mark On Wed, Feb 12, 2014 at 8:35 AM, Jordi Guillaumes i Pons <[email protected]> wrote: > Hello, > > After (finally!) networking TOPS-10 running on simh using the KDP/DUP > siumlator I'm trying to do the same with TOPS-20. I have built a TOPS-20 > system and I'm now trying to get DECNET (phase III) running on it. I have > followed the instructions contained here: > http://bitsavers.informatik.uni-stuttgart.de/pdf/dec/pdp10/TOPS20/DECnet-20/AA-5091B-TM_TOPS-20_DECnet-20_Programmers_Guide_Jan80.pdf > and used this tape: > http://bitsavers.informatik.uni-stuttgart.de/bits/DEC/pdp10/magtape/dec_distribs/decnet/DECNET-20_V2.1_2020_7-20-82.tap.gz > but I can't put it to work (NETCON complains about being unable to get the > network topology and FAL dies because an illegal instruction error). Since I > seem to remember someone was succesfull networking TOPS-20 over simh, I'd > like to know if I'm using the correct software kit, or if there is something > not documented to do to put this to work. > > Jordi Guillaumes i Pons > [email protected] > HECnet: BITXOV::JGUILLAUMES > > _______________________________________________ > Simh mailing list > [email protected] > http://mailman.trailing-edge.com/mailman/listinfo/simh _______________________________________________ Simh mailing list [email protected] http://mailman.trailing-edge.com/mailman/listinfo/simh
