On 2015-04-14 00:15, Alan Frisbie wrote:
There is one key issue with your configuration:
As soon as you specifically set a device address or vector you
implicitly disable auto configuration of all device addresses and
vectors. So early in your configuration you set an address for
the RQ device. The address you set is the default
auto-configuration address for the first MSCP controller so that
isn't necessary. Leave out that line. Your second MSCP
controller is not at the auto-configuration address for a
secondary MSCP controller, so that will have to be handled
separately (move device setup for devices with non-standard
addresses to the end of your configuration). The TS device is at
the default auto-configuration address (and vector) so merely
enable the device and DON'T set any address. The RY device is at
a non-standard auto-configuration address so move that section to
the end of the configuration. The LPT device is at the standard
auto-configuration address for the first LPT device, so don't set
address and vectors for this device.
That fixed the problem and I can now read tapes from MS0:.
Now if I can figure out why CON ONLINE ALL is taking such a
long time to execute...
Probing for some device you have SYSGENed, but isn't in simh?
CON will eventually time out on those, but it could take some time,
especially if something else is responding to the CSR address.
Johnny
--
Johnny Billquist || "I'm on a bus
|| on a psychedelic trip
email: [email protected] || Reading murder books
pdp is alive! || tryin' to stay hip" - B. Idol
_______________________________________________
Simh mailing list
[email protected]
http://mailman.trailing-edge.com/mailman/listinfo/simh
