Hello, The problem is that SIMS does not check destination address thoroughly enough when it looks like the address should be relayed through a host in the Client Hosts list.
It needs an option similar to one found in CommuniGate Pro relaying settings: relay to clients all addresses or just simple ones (without % hacks.) I'll see if that can be implemented in SIMS. on 12.01.2003 09:50, Joe Wagner at [EMAIL PROTECTED] wrote: > At Thu, 09 Jan 2003 20:37:58, Larry Stone <[EMAIL PROTECTED]> wrote: >>> Now how are you getting that to work? Here's what I get then I try that via >>> telnet on my secondary going to my primary: >>>> 571 <[EMAIL PROTECTED]@hypertouch.com> we do not relay. >>>> 571 <[EMAIL PROTECTED]@67.41.229.20> we do not relay. >>>> 571 <[EMAIL PROTECTED]@[67.41.229.20]> we do not relay. >> >> Is 67.41.229.20 the address of your SIMS server? Is it in the Client Hosts >> list? >> >> Try using the address of another host in the Client Hosts list and see what >> message you get (and use the third form of address above). > > > Ah ha, bingo! Thanks. Since I had recently switch DSL providers I hadn't my > primary's new address entered in the secondary's client host list. Adding > my primary's IP address to the secondary client list does allow me to do > this two stage relay. Interesting. There is a fair chance I might have been > bitten by that at some point. It is sometimes handy to enter a trusted > network's range of IP addresses as a trusted client. Now I will endeavor > to remember to leave out my secondary's IP address if I ever need to do > that again. > > Yes, I guess I would think that it doesn't make much sense for the client > list to be used to OK transmissions from email from any random connecting > machine rather than just from connecting clients. Is it an easy fix to > exclude the client host when checking for permission for a .smtp router entry? -- Best regards, Dmitry Akindinov ======================================================================= When answering to letters sent to you by the tech.support staff, make sure the original message you have received is included into your reply. ############################################################# This message is sent to you because you are subscribed to the mailing list <[EMAIL PROTECTED]>. To unsubscribe, E-mail to: <[EMAIL PROTECTED]> To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]> To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]> Send administrative queries to <[EMAIL PROTECTED]>
