> ________________________________
> 
> From: M. Ranganathan [mailto:[email protected]]
> Sent: Friday, September 04, 2009 1:16 PM
> To: Mossman, Paul (CAR:9D30)
> Cc: Saint, David (CAR:9D60); [email protected]
> Subject: Re: [sipX-dev] Problem building sipXopenfire RPM
> 
> 
> 
> 
> On Fri, Sep 4, 2009 at 1:04 PM, Paul Mossman 
> <[email protected]> wrote:
> 
> 
>       David wrote:
>       > Whenever I try to build the RPMs for sipXopenfire I get an
>       > error (shown below).
>       > I have sipx-openfire-3.6.4-2 installed on my FC8 system.
>       >
>       > My config command was:
>       >
>       > ../configure --with-distdir=`pwd`/../dist
>       > --cache-file=/tmp/ac-cache-file  SIPXPBXUSER=sipxchange
>       > OPENFIRE_HOME=/opt/openfire --enable-doxygen --enable-cdr
>       > --enable-conference --enable-mrtg --enable-openfire
>       >
>       > And the error is:
>       >
>       > + make DESTDIR=/var/tmp/sipxopenfire-4.1.0-root install
>       > make[3]: Entering directory 
> `/usr/src/redhat/BUILD/sipxopenfire-4.1.0'
>       > Makefile:789: warning: overriding commands for target
>       > `sipxopenfire.spec'
>       > Makefile:705: warning: ignoring old commands for target
>       > `sipxopenfire.spec'
>       > make[3]: Nothing to be done for `install'.
>       > make[3]: Leaving directory 
> `/usr/src/redhat/BUILD/sipxopenfire-4.1.0'
>       > + /usr/lib/rpm/find-debuginfo.sh
>       > /usr/src/redhat/BUILD/sipxopenfire-4.1.0
>       > find: /var/tmp/sipxopenfire-4.1.0-root: No such file 
> or directory
>       > error: Bad exit status from /var/tmp/rpm-tmp.74688 (%install)
>       
>       
>       I get the same error on CentOS 5.2.
>       
>       Odd, because our internal Fedora 8 and CentOS 5.2 build 
> servers don't
>       have this problem.
>       
>       Seems like this might be a re-occurrence of
>       http://track.sipfoundry.org/browse/XX-6249?  
> (INSTALL_ANT in blank in my
>       sipXopenfire Makefile too.)
>       
>       
> 
> 
> 
> 
> Just leave out enable-openfire and give it a try. If you have 
> installed openfire, it is enabled by default.
> 
> I do not build RPMs on my system but it seemed build the 
> openfire project fine.
> 
> Ranga
> 


That works, I guess the enable-openfire was messing it up.

Thanks...
Dave.
_______________________________________________
sipx-dev mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
sipXecs IP PBX -- http://www.sipfoundry.org/

Reply via email to