Hi All,
While verifying issue http://track.sipfoundry.org/browse/XX-7342 and
issue http://track.sipfoundry.org/browse/XX-6944, I observe the
following deviations from the previous results:
Case(i):
-----------
When a dialplan for a SIP Trunk is added or any other dialplan was
modified, the SIP Trunking service was asking for a service restart
along with Proxy and Registrar restart request, with a message in Job
Status page after restarting SIP Trunk as --> /Restarting:
sipXbridge-1/Internal SBC 1/4/10 1:28 PM 1/4/10 1:28 PM Completed/
(---->as per issue XX-7342)
Now, when verified this scenario in SCS 4.1.6-018102, following are the
results observed:
--> SIP Trunking service is NOT asked for restart and only SIP Proxy and
SIP Registrar services are asked for restart.
--> But, after restarting Proxy and Registrar, in Job Status page,
/Projection for: bandwidth/SIP trunk 2/25/10 1:57 PM 2/25/10 1:57 PM
Completed/ is seen, though sipxbridge is NOT restarted(--->sipxbridge
pid value is not changed and remained the same as before)
My query ----> Is this the expected behavior ?
Case(ii)
---------
When 'Server behind NAT' is enabled and clicked Apply, under System >>
Internet Calling >> Nat Traversal page, services for Media Relay ,SIP
Proxy and SIP Trunking are asked for restart . But, after restarting
Proxy and Registrar, in Job Status page, */only/* /File replication:
nattraversalrules.xml 2/25/10 2:08 PM 2/25/10 2:08 PM Completed/ is
shown.
My query ---> Since sipxbridge is restarted, Job Status should have
information about Job completion. Can I raise a JIRA for this?
Thank you in advance,
--
Regards,
Shruthi Prashanth Sarpamale
_______________________________________________
sipx-dev mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
sipXecs IP PBX -- http://www.sipfoundry.org/
