I understand there are config parameters. I also understand they don't work with sipX. My question was: was this implemeneted in SIP per RFC3840 section 10.7 as Dale and Paul were discussing in the mailing list entry I posted? Please fully read the mailing list post and you will understand what I'm asking.
Josh Patten Assistant Network Administrator Brazos County IT Dept. (979) 361-4676 On 3/9/2010 8:38 AM, Ke Liu wrote: > Polycom reply: > ----------> > Yes it was implemented. > > We have 2 ways of setting up BLF. The first uses the attendant.uri > parameter. > If you use BLF through that method we currently do not support the > automata resource type and so you cnnot configure 1 touch call > park/pickup. > > If you configure each resource to be monitored individually using: > attendant.resourceList.1.address="[email protected]" > attendant.resourceList.2.address="[email protected]" > attendant.resourceList.3.address="[email protected]" > then you can configure them to have the one touch transfer behavior by > adding: > attendant.resourceList.3.type="automata" > which would make the default action for the 3rd BLF resource (x8000) be > blind transfer instead of a new call. > > Only 1 of the 2 forms of BLF may be configure at a time. > > This is present in firmware 3.2.0 and newer > ----------> > > Then, we only support the RLS (attendant.uri parameter) method of BLF. > So, this is not compatible with sipXecs > > Ke Liu > [email protected] > Telephone (613) 763 6367 / ESN 393 6367 > > ------------------------------------------------------------------------ > ----------- > > > >> -----Original Message----- >> From: [email protected] >> [mailto:[email protected]] On Behalf Of Josh Patten >> Sent: Monday, March 08, 2010 10:47 AM >> To: [email protected] >> Subject: Re: [sipX-dev] Polycom 3.2 One Touch Transfer (automata) >> >> *bump* >> >> Josh Patten >> Assistant Network Administrator >> Brazos County IT Dept. >> (979) 361-4676 >> >> >> On 3/2/2010 3:45 PM, Josh Patten wrote: >> >>> I was wondering about the introduction of one touch transfer in >>> firmware >>> 3.2 for Polycoms. I found out there is not a way to set the >>> >> option in >> >>> the configuration files because if attendant.uri is set then the >>> automata settings are ignored. >>> >>> Here is a reference from a year ago from Paul Mossman and >>> >> Dale Worley. >> >>> >> http://www.mail-archive.com/[email protected]/msg04784.html >> >>> Did this ever go beyond discussion? >>> >>> >>> >> _______________________________________________ >> sipx-dev mailing list [email protected] List >> Archive: http://list.sipfoundry.org/archive/sipx-dev >> Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev >> sipXecs IP PBX -- http://www.sipfoundry.org/ >> >> > _______________________________________________ > sipx-dev mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-dev > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev > sipXecs IP PBX -- http://www.sipfoundry.org/ > _______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev sipXecs IP PBX -- http://www.sipfoundry.org/
