Baslingappa Bhujang wrote:
Hi All,
* Add a Audio codes Mediant 1000 gateway in the config UI
* Navigate to PSTN lines tab and add a PSTN line
* Navigate to E1/T1 tab and change "Line Build Out Loss" to
-15db.Click on Apply button
* Navigate to RTP/RTPC tab and change Country variant to 71.Click
on Apply button.
* Send profiles to the gateway and restart the required services.
* Down load the ini file from the config UI and upload to the
Mediant 1000 Gateway.
* Navigate to Configuration->PSTN Settings->Trunk Settings
Here "Line Build Out Loss" parameter still shows as 0db only it should
have changed to -15 db.
Could some one please advice me whether I am following the right steps
to change the "Line Build Out Loss" parameter. OR should I raise a
Jira for the same.
Country Variant Parameter is not reflected any where in the Web UI of
the gateway but it is seen in the MACID.ini file.Could some one guide
me where the parameter can be seen in the Web UI of the gateway.
Thanks,
Basling.
------------------------------------------------------------------------
_______________________________________________
sipx-dev mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
sipXecs IP PBX -- http://www.sipfoundry.org/
_______________________________________________
sipx-dev mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
sipXecs IP PBX -- http://www.sipfoundry.org/
