Hey that was my post :-P (I am dead_again) I don't think it has anything to do with that. Perhaps it just isn't supported in Audiocodes devices?
Josh Patten Assistant Network Administrator Brazos County IT Dept. (979) 361-4676 On 5/14/2010 9:04 AM, Saint, David (David) wrote: > > > >> -----Original Message----- >> From: [email protected] >> [mailto:[email protected]] On Behalf Of >> Naveen Krishna >> Sent: Friday, May 14, 2010 9:26 AM >> To: Mossman, Paul (Paul) >> Cc: [email protected] >> Subject: [sipX-dev] Reminder: Query regarding FXS gateway and >> analog phones >> >> Mossman, Paul (Paul) wrote: >> >>> Naveen wrote: >>> >>> >>>> * Is directed call pickup scenario (*78<user id>) supported for >>>> analog phones (registered through FXS gateway) ? >>>> >>>> >>> The ringing UA must support the dialog-info event package, >>> >> in order for the call to be picked up. It sounds like this >> is not the case. >> >>> (At one point the Avaya 3456 did not support this, though I >>> >> think it >> >>> does now.) >>> >>> >> I attached merged log of the scenario - merged.xml , my >> scenario is as follows >> >> User 230 calls 231 and upon ringing 232 tries to pickup the >> call by dialing *78231 , but 232 gets 404 not found response >> . (all the three phones used are Analog phones) >> >> FXS gateway used is AudioCodes MP114 FXS - with IP - 176.25.2.41 >> >> As you can see from the merged log Proxy sends Subscribe with >> requesting Event : Dialog (Frame 104) but receives 200 OK >> response (Frame 105) without Event : >> Dialog . I think this is the cause for the failure (as you >> mentioned previously). >> >> Please let me know whether this is design intent or should I >> raise an issue for the same ? >> >> Thank you , >> Naveen >> >>> -Paul >>> [email protected] >>> >>> >>> >> >> > Sounds similar to problems discussed in: > http://forum.voxilla.com/sipx-support-forum/sipx-directed-call-pickup-78xxx-28677.html > > It's likely an AudioCodes FXS limitation/bug. What version of the AudioCodes > firmware were you using? If you were using 6.00 you may want to go back and > try the 5.60 version. > > Dave. > _______________________________________________ > sipx-dev mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-dev > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev > sipXecs IP PBX -- http://www.sipfoundry.org/ > _______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev sipXecs IP PBX -- http://www.sipfoundry.org/
