>>> On 4/1/2009 at 10:28 AM, in message <[email protected]>, "Bob Anderson" <[email protected]> wrote: > > Hello All > > > > I am trying to integrate the Polycom/SpectraLink 8030 wireless > telephones with the SCS500 ( the 8030 sets have the SIP load on them)- > can anybody give me some direction on this? I have all the information > required from the polycom side > > > > > > Bob Anderson > > COMSOURCE Technologies Inc > > 3585 Laird Road, Unit 13 > > Mississauga,ON L5K 5Z8 > > 905.608.1400 x237 > > > >
You are brave! I'm assuming you can get them on your wireless network. Once that is done, you should be able to configure the tftp directory to point the sipx, and place the *cfg and firmwware files in the root of the tftp driectory (or create a directory and adjust the path from root for the spectra phone), then try seeing if it pulls the config on bootup. The config file looks "straightforward" to me, but i haven't spent too much time looking at it. It looks about 50 lines long (see page 54 in the manual below). http://www.polycom.com/global/documents/support/setup_maintenance/products/voice/SpectraLink_8020_8030_WT_Admin_SIP.pdf Assuming you get it on your wifi network, and get an IP address to it, you shoulld be able to give it a try. Post back how it goes! _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users
