I just set up sipXecs for the first time, and it seems very cool. However,
I can't seem to get outbound calling to work through and ITSP. I'm using
vbuzzer.com, which isn't in the supported ITSP's list, but I have had it
working with freeswitch for a while, and I didn't have to do anything
special to get it going. For phones, I'm using an spa2102, and it's working
fine, and it inbound calls through the ITSP (vbuzzer) are received at the
correct extension, and the call is fine. When I try to dial out, I get dead
aire, and eventually a busy signal. I have a gateway setup, and followed
the instructions on setting up an ITSP step by step .
Since vbuzzer wants a "1" sent for all north american calls (e.g. for
416-555-1212, I send it 14165551212), I setup a long distance dialing rule,
with "9" as the PSTN prefix, and an optional "1" long distance prefix, and
set my "vbuzzer" gateway as the gateway, which is routed through
sipXbridge.
My question is, when I make an outgoing call, what component of sipXecs
handles the dial plan? I want to check the logs to see what's going on, but
I'm not sure where to look. Here is the dial plan from authrules.xml:
<hostMatch>
<name>Long Distance</name>
<description>xxx</description>
<hostPattern>vbuzzer.com</hostPattern>
<userMatch>
<userPattern>1xxxxxxxxxx</userPattern>
<permissionMatch>
<permission>LongDistanceDialing</permission>
</permissionMatch>
</userMatch>
</hostMatch>
Thanks,
Paul
_______________________________________________
sipx-users mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users
sipXecs IP PBX -- http://www.sipfoundry.org/
