Awesome! -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Friday, January 22, 2010 11:22 AM To: sipx-users Subject: Re: [sipx-users] No audio out through opensbc
Looks like I had two problems. I used a copy of a config file when I built my SBCs. The config file contains the hardware addresses of the NICs so I suspect ARP weirdness. I had also overlooked using the default SBC in Internet Calling and because I am using external SBC's, I didn't have NAT Traversal options enabled. Changing these things seem to do the trick, it all came to life again. Mike On Fri, 22 Jan 2010 04:36:29 -0500, Picher, Michael wrote: > The only reason to add SBC's into sipX is if you are routing your ITSP > > calls out through them, which I believe you are not. You are utilizing > sipXbridge to route your calls to your ITSP. > > To sipX your users coming through your SBC's appear to be coming from > the internal interfaces of the SBCs. > > Since this is the case, it is very probable that you need to enable > media proxying in OpenSBC to make sure the media also appears to be > coming from the internal interface of the SBC. > > It is possible that sipXbridge may be choking on the funky registration > user information presented to sipX by the SBC. The sipXbridge log may > show something there. > > Also, under Internet Calling make sure that your internal IP addresses > are set. > > Mike > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of > [email protected] > Sent: Friday, January 22, 2010 12:59 AM > To: sipx-users > Subject: [sipx-users] No audio out through opensbc > > Sipx is set up without NAT Traversal, using two external opensbc/vyatta > servers. > > Calls To/From internal sipx to PSTN or other internal and trough ITSP's > work fine. > Remote users authenticated via opensbc are able to make calls but > receive ring only, no audio either way. > Calling a remote that is over the opensbc server either from PSTN or > internal, they get ring and no audio either way. > > Since they are able to make calls and get full audio, it seems that > ports aren't the issue, at least one way. > So basically, everything works but unable to send RTP to users > authenticated using opensbc. > > They are getting the ring which means that sipx is doing the call setup > but then there is no RTP. > > Not quite sure what to look for in the logs because there isn't anything > obvious yet. > Could someone send a few thoughts on what I should be looking for. > > Thanks much. > > Mike > > > _______________________________________________ > sipx-users mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users > sipXecs IP PBX -- http://www.sipfoundry.org/ _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
