On Tue, Feb 9, 2010 at 8:53 AM, Jeff Gilmore <[email protected]> wrote:
> <==I am resending this message, as I never saw it come back on the list==> > > I am testing a new trunk for inbound calling. Outbound works fine on this > trunk. > > When I place a call from the PSTN, the sipx target extension rings > immediately. However, the call does not connect for another 10 seconds or > so. > > I have attached a trace of a call that went like this: > > 1. Placed call from an outside phone (i.e not attached to my switch). > 2. The sipx extension which has the called DID as an alias rings > immediately. > 3. I pick up after 1 ring. > 4. I hear dead air on both phones (and no ringing, or ring tone on either). > 5. After about 10 seconds, I hear a brief ring tone on the calling phone. > 6. The audio connects, > 7. I stay on the line for about 10 seconds. > 8. I hang up the sipx extension > > That extension is a Linksys SPA2102 (although the behavior was similar when > I routed the DID to a Polycom 320). On either device, a call placed from > another sipx extension connects normally. > > Would any of you angels of mercy out there be willing to read the trace and > see if you can tell why it does not respond immediately when the extension > goes off-hook? > > > > One thing that might be weird, if you see something that doesn't make > sense, is that there are 2 public IP's for the server (each NATed to the > same internal IP). One is a private circuit used only for the SIP trunk to > the ITSP. The other is where remote phones would connect (and that one is > what the public split-DNS records for my server point to--the other is > configured only with IP addresses on the ITSP switch and on my SIPX). This > call should only travel on the private circuit. > > Thanks, > > Jeff > > > _______________________________________________ > sipx-users mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users > sipXecs IP PBX -- http://www.sipfoundry.org/ > why is the contact trying "ecovillage" instead of the internal user line number? Are you doing something else weird on the remote user, like trying to register them by alias instead of user line (frame 31)? Is the remote ATA set for symmetric RTP?
_______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
