On 4/4/2011 7:20 PM, Mike Haun wrote:
Content-Type: text/plain;
charset="utf-8"
Content-Transfer-Encoding: 8bit
Organization: SipXecs Forum
In-Reply-To:<[email protected]>
X-FUDforum: 08063afcdd00a6e76393c5b9527381e8<58376>
Message-ID:<[email protected]>
Has there been any resolution to this? I've had the exact
same problem and can't figure it out.
I'm running Sipx 4.2.1-018971 with the AudioCodes MP-114 FXO
5.80A firmware. I cannot get sipx to send the configuration
to the MP114 even though it is suppose to. I have saved the
.ini file to my local drive then have uploaded it to the AC
device via it's web interface and that seems to work fine
for that part, but...
The biggest problem that is driving me crazy is that I
cannot get it to disconnect if the PSTN hangs up first!
I've tried polarity reversal and current disconnect but
neither of them work. Very frustrating.
If anyone has a good progress tones file that works with
POTS lines from AT&T then I would really like to try that.
Thanks.
Here are my notes on a MP-118 with 5.40A.013.004 and my ini file is
attached:
Debugging AudioCodes MP-118 FXO
http://www.abptech.com/support/faqs/faq_Audiocodes_Guide.html
Enable Hold=>True
The main line is the only phone that can call out. No matter what we do
we get the dial tone but are unable to process an outgoing call.
Hold Format=>SendOnly
same problem
Enable Hold =>False , burn.
burn and reset.
uploaded usa_tones_12.ini
added the ntp server back.
dial mode=>one stage
reset ini file as the usa_tones_12.ini seemed to have wiped out everything.
dtmfvolume -15 =>0
other dtmf volume -11=>0
Enable Continuity Tones =>enable
Silence Detection Method none=>all
deleted usa_tones.dat
Enable Polarity Reversal=>true
On Sun, 2010-04-11 at 03:04 -0500, Josh Patten wrote:
>OK I've found what I think is the fix, but let me run it by
everyone>here to make sure it won't break anything.>>In the Audiocodes
I disabled PRACK: Protocol Configuration >> Protocol>Definition >> SIP
General Parameters >> PRACK Mode = Disable (was:>Supported)>>Anyone
know why PRACK causes issues with forking in 4.0.4 and not>4.1.7? Will
not having PRACK enabled cause issues?
Using PRACK may significantly increase the amount of state that the
gateway thinks it needs to keep for early dialogs, which would be
consistent with the resource errors that were in your logs. To be sure,
you'd have to ask Audiocodes. In any event, for what you're doing PRACK
offers no added value, so leaving it off is just fine.
--
Regards
--------------------------------------
Gerald Drouillard
Technology Architect
Drouillard& Associates, Inc.
http://www.Drouillard.biz
;**************
;** Ini File **
;**************
;Board: MP-118 FXO
;Serial Number: 1431829
;Slot Number: 1
;Software Version: 5.40A.013.004
;DSP Software Version: 204IM =» 540.14
;Board IP Address: 192.168.10.7
;Board Subnet Mask: 255.255.255.0
;Board Default Gateway: 192.168.10.1
;Ram size: 32M Flash size: 8M
;Num DSPs: 2 Num DSP channels: 8
;Profile: NONE
;-----------------------------------------
[SYSTEM Params]
DNSPriServerIP = 192.168.10.6
SyslogServerIP = 10.1.1.89
VXMLFIleName = ''
NTPServerIP = 192.168.10.6
NTPUpdateInterval = 3600
VoiceMenuPassword = 'disable'
[BSP Params]
PCMLawSelect = 3
LocalMediaDefaultGW = 192.168.1.1
LocalMediaIPAddress = 192.168.1.7
LocalMediaSubnetMask = 255.255.255.0
LocalControlIPAddress = 192.168.1.7
LocalControlSubnetMask = 255.255.255.0
StorageServerNetworkAddress = 255.255.255.255
[ATM Params]
[Analog Params]
MinFlashHookTime = 100
FXSLoopCharacteristicsFilename = 'MP11x-02-1-FXS_16KHZ.dat'
[ControlProtocols Params]
AdminStateLockControl = 0
[MGCP Params]
[MEGACO Params]
EP_Num_0 = 0
EP_Num_1 = 1
EP_Num_2 = 0
EP_Num_3 = 0
EP_Num_4 = 0
[PSTN Params]
[SS7 Params]
[Voice Engine Params]
VoicePromptsFileName = ''
InputGain = 15
BrokenConnectionEventTimeout = 100
RFC2833PayloadType = 101
FarEndDisconnectSilenceMethod = 0
FarEndDisconnectSilencePeriod = 120
CallProgressTonesFilename = 'usa_tones_12.dat'
[WEB Params]
[SIP Params]
ENABLECALLERID = 1
MAXDIGITS = 3
ISPROXYUSED = 1
ISWAITFORDIALTONE = 1
ISTWOSTAGEDIAL = 0
ENABLECURRENTDISCONNECT = 1
ENABLEREVERSALPOLARITY = 1
CHANNELSELECTMODE = 1
GWDEBUGLEVEL = 5
ENABLEEARLYMEDIA = 1
ISUSERPHONE = 0
PROXYNAME = '192.168.10.6'
PASSWORD = ''
ENABLESILENCEDISCONNECT = 1
PROGRESSINDICATOR2IP = -1
ALWAYSSENDTOPROXY = 1
CDRSYSLOGSERVERIP = 0.0.0.0
PSTNALERTTIMEOUT = 180
PREFERROUTETABLE = 1
ISFAXUSED = 1
DISCONNECTONDIALTONE = 1
ENABLETCPCONNECTIONREUSE = 0
ENABLESEMIATTENDEDTRANSFER = 1
REDUNDANTROUTINGMODE = 2
[SCTP Params]
[VXML Params]
[IPsec Params]
[Audio Staging Params]
;
; *** TABLE DspTemplates ***
; This table contains hidden elements and will not be exposed.
; This table exists on board and will be saved during restarts
;
;
; *** TABLE PREFIX ***
;
;
[ PREFIX ]
FORMAT PREFIX_Index = PREFIX_DestinationPrefix, PREFIX_DestAddress,
PREFIX_SourcePrefix, PREFIX_ProfileId, PREFIX_MeteringCode,
PREFIX_SrcIPGroupID, PREFIX_DestHostPrefix, PREFIX_DestIPGroupID,
PREFIX_SrcHostPrefix, PREFIX_TransportType, PREFIX_SrcTrunkGroupID;
PREFIX 0 = *, 192.168.10.6, *, 1, 255, -1, , -1, , -1, -1;
[ \PREFIX ]
;
; *** TABLE CoderName ***
;
;
[ CoderName ]
FORMAT CoderName_Index = CoderName_Type, CoderName_PacketInterval,
CoderName_rate, CoderName_PayloadType, CoderName_Sce;
CoderName 0 = g711Ulaw64k, 20, 0, 255, 0;
CoderName 1 = g711Alaw64k, 20, 0, 255, 0;
CoderName 2 = g729, 20, 0, 255, 0;
CoderName 5 = g711Ulaw64k, 20, 0, 255, 0;
CoderName 6 = g711Alaw64k, 20, 0, 255, 0;
CoderName 7 = g729, 20, 0, 255, 0;
[ \CoderName ]
;
; *** TABLE TrunkGroup ***
;
;
[ TrunkGroup ]
FORMAT TrunkGroup_Index = TrunkGroup_TrunkGroupNum, TrunkGroup_FirstTrunkId,
TrunkGroup_FirstBChannel, TrunkGroup_LastBChannel, TrunkGroup_FirstPhoneNumber,
TrunkGroup_ProfileId, TrunkGroup_LastTrunkId, TrunkGroup_Module;
TrunkGroup 0 = 1, 255, 1, 8, 100, 1, 255, 255;
[ \TrunkGroup ]
;
; *** TABLE PstnPrefix ***
;
;
[ PstnPrefix ]
FORMAT PstnPrefix_Index = PstnPrefix_DestPrefix, PstnPrefix_TrunkGroupId,
PstnPrefix_SourcePrefix, PstnPrefix_SourceAddress, PstnPrefix_ProfileId,
PstnPrefix_SrcIPGroupID, PstnPrefix_DestHostPrefix, PstnPrefix_SrcHostPrefix;
PstnPrefix 0 = *, 1, *, *, 1, -1, , ;
[ \PstnPrefix ]
;
; *** TABLE ProxyIp ***
;
;
[ ProxyIp ]
FORMAT ProxyIp_Index = ProxyIp_IpAddress, ProxyIp_TransportType,
ProxyIp_ProxySetId;
ProxyIp 0 = 192.168.10.6, 0, 0;
[ \ProxyIp ]
;
; *** TABLE TxDtmfOption ***
;
;
[ TxDtmfOption ]
FORMAT TxDtmfOption_Index = TxDtmfOption_Type;
TxDtmfOption 0 = 4;
[ \TxDtmfOption ]
;
; *** TABLE TrunkGroupSettings ***
;
;
[ TrunkGroupSettings ]
FORMAT TrunkGroupSettings_Index = TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode, TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName, TrunkGroupSettings_ContactUser,
TrunkGroupSettings_ServingIPGroup;
TrunkGroupSettings 0 = 1, 1, 0, , , -1;
[ \TrunkGroupSettings ]
;
; *** TABLE TargetOfChannel ***
;
;
[ TargetOfChannel ]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type;
TargetOfChannel 0 = 100, 1;
TargetOfChannel 1 = 100, 1;
TargetOfChannel 2 = 100, 1;
TargetOfChannel 3 = 100, 1;
TargetOfChannel 4 = 100, 1;
TargetOfChannel 5 = 100, 1;
TargetOfChannel 6 = 100, 1;
TargetOfChannel 7 = 100, 1;
[ \TargetOfChannel ]
;
; *** TABLE ProxySet ***
;
;
[ ProxySet ]
FORMAT ProxySet_Index = ProxySet_EnableProxyKeepAlive,
ProxySet_ProxyKeepAliveTime, ProxySet_ProxyLoadBalancingMethod,
ProxySet_IsProxyHotSwap;
ProxySet 0 = 0, 60, 0, 0;
[ \ProxySet ]
_______________________________________________
sipx-users mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users/
