Re: [sipx-users] Valcom VIP-120 intercom setup

Mon, 02 May 2011 15:58:16 -0700

I tried that. See below. It still isn't registering. Sipx is the DNS server and it is the default setup, so I believe I am using SRV.
I wish there was some sort of debugging on the Valcom. It has a web interface, but I can't figure out the login.
By the way, I completely made up the value for Auto Destination. I'm not even sure what that means.



On 5/2/2011 5:34 PM, Josh M. Patten wrote:

If you’re using SRV try changing the SIP server to the same as your realm (leave outbound proxy the same)

 

Josh Patten

Brazos County Network Engineer

979.361.4676

 

From: [email protected] [mailto:[email protected]] On Behalf Of Matthew Kitchin (public/usenet)
Sent: Monday, May 02, 2011 5:00 PM
To: Discussion list for users of sipXecs software
Subject: [sipx-users] Valcom VIP-120 intercom setup

 

I'm trying to get one of these setup with sipx 4.4.
Can anyone nudge me in the right direction? I think I have included most of the relevant conifg screens below.
The server is 4.4. I created an user with the extension 90 and sip password intercom
(This is for testing and this server is not exposed to the public network)
pbx.fl215.sipx.voip is at 10.81.9.5
I can't even get it to register.
Their config guides are here:
http://www.valcom.com/techsupport/ip_solutions/config-guides.htm
The guide doesn't seem to tell me a lot.
I will call them next, but I thought I would check here first since there are some people on here that have had good luck with these.

Thanks,
Matthew




_______________________________________________
sipx-users mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users/



_______________________________________________
sipx-users mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users/

Reply via email to