Ok, I must be doing something wrong in my set up with Cartes du Ciel.
I installed the current version of it and also installed the encoder
driver with it. I configured it for the Intelliscope, as directed.
I go through the alignment procedure and sync it after each
selection. The problem is that I do not get an interface between the
scope and PC. I'm assuming that when done correctly, the cursor will
move with the scope?
When I go to the main menu to select telescope, the only item I can
select is the scope option. The "show scope position" option, which
I believe is what I need, is grayed out like it hasn't been
installed. I thought that the encoder driver would install it. Is
there an additional driver I need to install?
I believe everything else is ok with it. Thanks for the help and in
relieving my frustration!
Thanks,
Dan James
Greenville, Pa
XT8i
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/skychart-discussion/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
