> Leonard,
> CdC uses ASCOM to talk to the ArgoNavis, but not in native AN
> language. If you have not upgraded to the latest AN firmware then set
> CdC's ASCOM driver and the serial port you use in the AN to "Sky
> Commander" and 9600 baud. Remember that the AN will need to be
> powered down before any changes take place. If you have a ServoCat
> hooked to the AN then set the port on the AN to "ServoCat" and use
> the Servocat driver in the ASCOM platform in CdC. That way GoTo's
> will work from CdC. If you have the newest version of the AN firmware
> then it will emulate a large list of telescope protocols so take your
> pick but just make sure they Match between the AN and ASCOM.
> Also make sure you use the "ArgoNavis" rs232 connector if your kit
> came with other flavors of connectors.
> Bob
By the way, I haven't installed the ASCOM plugin for CdC. I see that now.
I've installed the Encoder and Meade plugin. That's probably obvious from
what I've said before. Should I install the ASCOM plugin and use that,
instead of the Encoder plugin, or does it matter with AN 2.0.0?
Thanks,
==Leonard
SPONSORED LINKS
| Chart software | Organization chart software | Science kits |
| Science education | Astronomy gift | Flow chart software |
YAHOO! GROUPS LINKS
- Visit your group "skychart-discussion" on the web.
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
