I have managed to modprobe the e100 module and that hasn helped at
all....and I also tried the 2.4.16 kernel and I am getting the same error...
I have attached some outputs for you to look at...if you want to see
anything else please ask me...
Adam Hewitt wrote:
> Hi All,
>
> I have just upgraded my kernel to 2.4.18 and my network
> card/networking no longer works. If I run ifconfig, i get my card with
> my IP address, if I run route -n I get everything that should be
> there, if I look in /etc/network/interfaces I have my network card
> setup with the apporpriate info, and if I run lsmod I can see my cards
> module driver there.....and yet it still doesn work.
>
> My card is an eepro100 which I have been told doesn work very well,
> and that I should install the e100 module, which I have but I get the
> following error when I try and install it:
>
> Hint: insmod errors can be caused by incorrect module parameters,
> including inva
> lid IO or IRQ parameters
> /lib/modules/2.4.18-686/kernel/net/e100.o: init_module: No such device
> /lib/modules/2.4.18-686/kernel/net/e100.o: insmod
> /lib/modules/2.4.18-686/kernel
> /net/e100.o failed
> /lib/modules/2.4.18-686/kernel/net/e100.o: insmod e100 failed
>
> I am able to ping both my IP address and the Loopback address....
>
> Any help would be appreciated,
>
> Adam.
>
eth0 Link encap:Ethernet HWaddr 00:D0:B7:C0:55:B5
inet addr:192.168.0.3 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:2646 (2.5 KiB)
Interrupt:11 Base address:0xde80 Memory:d4871000-d4871c40
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:80 errors:0 dropped:0 overruns:0 frame:0
TX packets:80 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:8624 (8.4 KiB) TX bytes:8624 (8.4 KiB)
vmnet1 Link encap:Ethernet HWaddr 00:50:56:C0:00:01
inet addr:172.16.153.1 Bcast:172.16.153.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:39 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
vmnet8 Link encap:Ethernet HWaddr 00:50:56:C0:00:08
inet addr:172.16.81.1 Bcast:172.16.81.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Module Size Used by Tainted: PF
e100 60164 1
vmnet 17632 6
parport_pc 21960 0
parport 22944 0 [parport_pc]
vmmon 18772 0 (unused)
mousedev 3808 0 (unused)
hid 17664 0 (unused)
usbcore 48192 1 [hid]
input 3328 0 [mousedev hid]
rtc 5368 0 (autoclean)
unix 13316 9 (autoclean)
ide-disk 6592 2 (autoclean)
ide-probe-mod 7968 0 (autoclean)
ide-mod 129420 2 (autoclean) [ide-disk ide-probe-mod]
ext2 30400 1 (autoclean)
ext3 56544 0 (autoclean)
jbd 34968 0 (autoclean) [ext3]
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
172.16.81.0 0.0.0.0 255.255.255.0 U 0 0 0 vmnet8
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
172.16.153.0 0.0.0.0 255.255.255.0 U 0 0 0 vmnet1
0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 eth0
