Hi Sluggers, Last night a server died, and on reboot there are the following error messages that constantly appear in the log: eth0: Too much work at interrupt, IntrStatus=0x0001. Oct 23 10:01:25 rrserver kernel: scsi0: PCI error Interrupt at seqaddr = 0x8 Oct 23 10:01:25 rrserver kernel: scsi0: Data Parity Error Detected during address or write data phase
The eth0 error doesn't happen as often as the scsi error, I think it only happens when someone tries to remotely connect to the server. The scsi error happens every 30 seconds or so, I guess this is becuase it has a scsi hard drive. Output of lspci: 00:00.0 Host bridge: VIA Technologies, Inc. VT8367 [KT266] 00:01.0 PCI bridge: VIA Technologies, Inc. VT8367 [KT266 AGP] 00:05.0 Multimedia audio controller: C-Media Electronics Inc CM8738 (rev 10) 00:09.0 USB Controller: VIA Technologies, Inc. USB (rev 50) 00:09.1 USB Controller: VIA Technologies, Inc. USB (rev 50) 00:09.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 51) 00:0c.0 VGA compatible controller: S3 Inc. 86c764/765 [Trio32/64/64V+] (rev 44) 00:0d.0 SCSI storage controller: Adaptec AIC-7892A U160/m (rev 02) 00:0f.0 Ethernet controller: D-Link System Inc RTL8139 Ethernet (rev 10) 00:11.0 ISA bridge: VIA Technologies, Inc. VT8233A ISA Bridge 00:11.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06) 00:11.2 USB Controller: VIA Technologies, Inc. USB (rev 23) 00:11.3 USB Controller: VIA Technologies, Inc. USB (rev 23) This machine has been running for nearly a year flawlessly, no recent changes, and it is not connected to the internet, so this is why I think its a hardware issue - But where? Any suggestions appreciated. Thanks, Scott -- Scott Ragen Support Manager/IT Administrator Roadtech Systems www.roadtech.com.au PH: +61 2 9807 3516 FAX: +61 2 9808 5294 -- SLUG - Sydney Linux User's Group - http://slug.org.au/ More Info: http://lists.slug.org.au/listinfo/slug
