Thanks....I've never messed with preamble....it is currently set to long. It
stayed up for 20 minutes this time. Just reset the APPO for a third time and
the clients came back. I'm thinking the APPO is flaking out from the heat.
It's been in service for three weeks now.


----- Original Message ----- 
From: "Sam" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, July 10, 2003 5:17 PM
Subject: Re: [smartBridges] Air Point Total died today


> Bobby,
>
>
> Check to make sure your preamble is set to long, instead of short.
>
> I had the exact same problem. Drove me crazy for three weeks (and cost me
> $3000.00). As soon as I changed the preamble to long, my clients stopped
> disappearing/reappearing.
>
> Good luck,
> Sam
>
> On Thu, 10 Jul 2003, Bobby Bounds wrote:
>
> > Thanks Vasu....I'm logged into the A/P and it seems to be dropping all
> > the clients....then a minute later, they're back...then gone again. I am
> > now suspicous of the A/P more than the Total. It is very hot here
> > today....hottest day all year so far....easily 110 Fahrenheit on the
> > roof.
> >   ----- Original Message -----
> >   From: Vasu (sB Tech Team)
> >   To: [EMAIL PROTECTED]
> >   Sent: Thursday, July 10, 2003 4:43 PM
> >   Subject: RE: [smartBridges] Air Point Total died today
> >
> >
> >   Can you just try to restore the device to factory defaults and then
> > scan for the radios in CB mode? Once associated try to ping to the AP
> > wirelessly and then login in to the unit wirelessly
> >
> >
> >
> >   Best Regards,
> >
> >
> >
> >   Vasu
> >
> >   (sB Support Team)
> >
> >
> >
> >
> >
> >   -----Original Message-----
> >   From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Bobby Bounds
> >   Sent: Friday, July 11, 2003 6:34 AM
> >   To: '[EMAIL PROTECTED]'
> >   Cc: '[EMAIL PROTECTED]'
> >   Subject: [smartBridges] Air Point Total died today
> >
> >
> >
> >   It's over 100 degrees here today. Ethernet side is up . . . you can
ping the APT from the LAN side (but not from the WAN side) but you cannot
ping past it to the A/P. The APT is in CB mode. Any ideas? Cycled power
several times....no good.
> >
> >
> >
> >   Bobby Bounds
> >
> >   Airwave Internet, LLC
> >
> >   [EMAIL PROTECTED]
> >
> >
> >
> >
> >
>
> The PART-15.ORG smartBridges Discussion List
> To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe
smartBridges <yournickname>
> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe
smartBridges)
> Archives: http://archives.part-15.org
>


The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges 
<yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org  

Reply via email to