Did you try this APPO for a week or so before installing it ?? I might be the APPO
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rudolph Worrell Sent: Tuesday, September 09, 2003 2:25 PM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] Long Ethernet runs... I would check your ethernet card and see if it is set to 100 or 10 or to auto sensing. I have seen this with a dell built in ethernet card and I had to force it to 10mbps instead of auto. This is just a quick thought. It may very well be a result of the long run. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Patrick Sent: Tuesday, September 09, 2003 12:10 PM To: [EMAIL PROTECTED] Subject: [smartBridges] Long Ethernet runs... We just finished mounting our new setup 220 ft up on a spectrasite tower and I seem to be having wierd issues with an AP Total. The ethernet connectivity randomly drops. I have my laptop plugged directly into it and it will work for a few minutes then show disconnect and then come back etc. I figured it was probably due to using the stock 12volt wall wart. I bought some radio shack 18v 1amp units and when I plug them in, the powershot unit's light looks flaky. It almost looks like it is flashing really fast. I tried 3 different units, both neg tip and positive tip. I put the 12 volt back and the light it good, but the unit keeps dropping the ethernet. Any ideas? Anyone use the Radio Shack units for long runs? Patrick ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
