Thank you for your suggestion, this may be the idea for the next generation product. In X02, you can configure one radio to be in standby mode just incase the primary one goes bad.
Alex sB Tech Support [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Blazen Wireless Sent: Tuesday, September 23, 2003 3:43 AM To: [EMAIL PROTECTED] Subject: Re: [smartBridges] Looking for Range and Spread of Airpoint Pro Total The only problem I see with a unit like this is if one goes bad you have to replace the while unit. That was the COOL feature about the AP-1000 or Ap-2000 is you had separate radio cards you could slide in or out depending on what you wanted to do or if one went bad you simply replaced it not the whole unit. You might want to look into something like that in the future saves time and less of a hassles for both parties! ----- Original Message ----- From: "sB Tech Support" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, September 22, 2003 11:32 AM Subject: RE: [smartBridges] Looking for Range and Spread of Airpoint Pro Total The XO2 will have 2 radios and thus 2 external connector. You can set this up as repeater, Alex sB Tech Support [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of The Wirefree Network Sent: Tuesday, September 23, 2003 1:21 AM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] Looking for Range and Spread of Airpoint Pro Total If this is an aPPT with an external jack, that would be SWEET. That is...IF it has 2 radios in it. I would love to use the aPPT to shoot back to my head-end, then come out of it to an external sector PANEL at my repeater locations. Would save me from having to mount 2 radios. I have been asking for this since they FIRST came out with the "repeater" idea in one box. I did see the new aPPo with 2 external antenna jacks with 2 internal radios...but that would require 2 antennas. Still a good solution...but for ease, I would like to just mount one radio (box) and one antenna. sB...is that what this customer has in hand?? Sully -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Kevin Proctor Sent: Monday, September 22, 2003 9:20 AM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] Looking for Range and Spread of Airpoint Pro Total I haven't seen any of those, yet. That doesn't mean that we don't have them. It just means I haven't seen it, yet. The only reason I asked if you had bought it from us, was that if you had, I was ready to swap the unit for you to do what you wanted if necessary. I would agree. If it has a connector, you should be able to nail another antenna to it. I might suspect that you would need to go to the advanced tab in SimpleMonitor and select the antenna port, though, to re-route your RF to the correct antenna. Kevin B. Proctor Customer Service Internet and International Orders Electro Comm Distributing Inc 5015 Paris St Denver CO 90239 USA Phone: +1-303-371-8182 800-525-0173 FAX: +1-303-371-8158 800-423-8018 [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Virtual North Sent: Monday, September 22, 2003 8:48 AM To: [EMAIL PROTECTED] Subject: Re: [smartBridges] Looking for Range and Spread of Airpoint Pro Total Hi Kevin. No I didn't buy the APPT from you. This is one of the newer units and it has an external antenna jack. The documentation says " .... Using a high gain external Omni / Directional antennas, it can provide range of upto 32 Kilometers and provides data rates upto 11Mbps ... " so I am assume that using an external antenna along with the integrated antenna is fine. Dan Good, WRAP ----- Original Message ----- From: "Kevin Proctor" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, September 22, 2003 8:31 AM Subject: RE: [smartBridges] Looking for Range and Spread of Airpoint Pro Total > You don't. You can use any antenna you want to with the APPT as long as > what you want to use is the integrated 13dbi antenna. > > Did you buy that from us? > > Kevin B. Proctor > Customer Service > Internet and International Orders > Electro Comm Distributing Inc > 5015 Paris St > Denver CO 90239 > USA > > Phone: +1-303-371-8182 > 800-525-0173 > FAX: +1-303-371-8158 > 800-423-8018 > [EMAIL PROTECTED] > > <snip> ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
