Are you trying to connect to pcmcia cards? If so make sure u have a horizontal omni for optimal coverage.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Wayland Sothcott Sent: Tuesday, November 18, 2003 3:21 AM To: [EMAIL PROTECTED] Subject: Re: [smartBridges] Short distance coverage I am just after the general principle. I can't draw maps. Three buildings in a row. Middle one is largest, 3 floor, one is two floor and other is ground floor. The ground floor building is 10 metres away, the 2 floor is 30 metres away from the antenna. If I put a 12db omni at the roof of the 3 floor middle one will I get good coverage at ground level? Wayland. ----- Original Message ----- From: "Andrew Watkins" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, November 18, 2003 10:56 AM Subject: RE: [smartBridges] Short distance coverage > Without a map or site layout its hard to specify what goes where - e.g. is > the AP in the middle or on the perimeter? Can you elaborate with a drawing > of the site(s)? > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > On Behalf Of Wayland Sothcott > Sent: Tuesday, November 18, 2003 8:59 AM > To: [EMAIL PROTECTED] > Subject: [smartBridges] Short distance coverage > > Hello, > > I have a job where we are connecting four buildings which are within 40 > metres of each other. We need good strong coverage in that area and don't > want to have to use external antennas except on the airPoint. What would be > a suitable location and antenna type to achive this? I imagine a 12db omni > mounted above the roof of the middle building would actually spread the > signal too high up out of reach of the ground. Yet an antenna mounted inside > the building would have too much brick to go through. > > What are your experiences? > > Thanks, > Wayland. > > > The PART-15.ORG smartBridges Discussion List To Join: > mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges > <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type > unsubscribe smartBridges) > Archives: http://archives.part-15.org > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
