I have 2 APPO's back to back without a switch and so far it works fine. ----- Original Message ----- From: "Andrew Watkins" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, November 18, 2003 5:32 AM Subject: [smartBridges] Crossover Cable Instead Of Hub/Switch At Relay Site
> I am using two aPPO's, connected using a Netgear 10Mps hub located in a > dairy of a local farmer, to relay a signal around a hill. > > After reading the posts on the pros and cons of using a switch when > connecting 2 radios together, would an alternative be to use a crossover > cable and two male-male RJ45 connectors to join the two aPPO's directly? > > Is anyone using this at the moment? I'm going down to the site later this > week to test it so will post my results back as and when. > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org > The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
