Try the new firmware 0.01.08 see if that helps maybe the firmware got corrupted or maybe a bad unit?
----- Original Message ----- From: "Steve Good" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, November 24, 2003 7:39 AM Subject: RE: [smartBridges] WUSB11 on Smartbridge network The AP is SB and the firmware is 1.07 this unit was working fine until I took it and tried to go to another part of town and connect to a different SB APTO that I have and then it started. and then Bring it back to the location where it was working and no luck. Thanks, Steve ________________________________ From: [EMAIL PROTECTED] on behalf of Blazen Wireless Sent: Mon 11/24/2003 8:22 AM To: [EMAIL PROTECTED] Subject: Re: [smartBridges] WUSB11 on Smartbridge network What firmware are you running on those two units? is the access point SB or something else? ----- Original Message ----- From: "Steve Good" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, November 24, 2003 7:17 AM Subject: RE: [smartBridges] WUSB11 on Smartbridge network I have 2 ABT that can associate with the tower but never pass traffic they can not ping anything other then their own local address one is a older one from June and one is the newer ones that have the white mounting bracket. I have reset and reset and reset the unit and still no luck. Any ideas on the SB units? Thanks, Steve The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
