Hello,

here are the datas for a Seagate FreeAgent Go 320GB:

--------------------------------------------------------------
dockstar ~ # smartctl -d sat,12 -a /dev/sda
smartctl 5.39 2009-12-09 r2995 [armv5tel-softfloat-linux-gnueabi] (local 
build)
Copyright (C) 2002-9 by Bruce Allen, 
http://smartmontools.sourceforge.net

=== START OF INFORMATION SECTION ===
Device Model:     ST9320325AS
Serial Number:    XXXXXXXX
Firmware Version: 0002BSM1
User Capacity:    320.072.933.376 bytes
Device is:        Not in smartctl database [for details use: -P showall]
ATA Version is:   8
ATA Standard is:  ATA-8-ACS revision 4
Local Time is:    Sat Jan 23 00:56:46 2010 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Offline data collection status:  (0x00) Offline data collection activity
                                         was never started.
                                         Auto Offline Data Collection: 
Disabled.
Self-test execution status:      (   0) The previous self-test routine 
completed
                                         without error or no self-test 
has ever
                                         been run. 

Total time to complete Offline 

data collection:                 (   0) seconds. 

Offline data collection 

capabilities:                    (0x73) SMART execute Offline immediate. 

                                         Auto Offline data collection 
on/off support.
                                         Suspend Offline collection upon 
new
                                         command. 

                                         No Offline surface scan 
supported.
                                         Self-test supported. 

                                         Conveyance Self-test supported. 

                                         Selective Self-test supported. 

SMART capabilities:            (0x0003) Saves SMART data before entering 

                                         power-saving mode. 

                                         Supports SMART auto save timer. 

Error logging capability:        (0x01) Error logging supported. 

                                         General Purpose Logging 
supported.
Short self-test routine 

recommended polling time:        (   1) minutes. 

Extended self-test routine 

recommended polling time:        (  99) minutes. 

Conveyance self-test routine 

recommended polling time:        (   2) minutes. 

SCT capabilities:              (0x103b) SCT Status supported. 

                                         SCT Feature Control supported. 

                                         SCT Data Table supported. 


SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE 
UPDATED  WHEN_FAILED RAW_VALUE
   1 Raw_Read_Error_Rate     0x000f   117   099   006    Pre-fail 
Always       -       141064238
   3 Spin_Up_Time            0x0003   097   097   000    Pre-fail 
Always       -       0
   4 Start_Stop_Count        0x0032   100   100   020    Old_age 
Always       -       295
   5 Reallocated_Sector_Ct   0x0033   100   100   036    Pre-fail 
Always       -       0
   7 Seek_Error_Rate         0x000f   065   060   030    Pre-fail 
Always       -       3177652
   9 Power_On_Hours          0x0032   100   100   000    Old_age 
Always       -       135
  10 Spin_Retry_Count        0x0013   100   100   097    Pre-fail 
Always       -       0
  12 Power_Cycle_Count       0x0032   100   037   020    Old_age 
Always       -       110
184 End-to-End_Error        0x0032   100   100   099    Old_age   Always 
       -       0
187 Reported_Uncorrect      0x0032   100   100   000    Old_age   Always 
       -       0
188 Command_Timeout         0x0032   100   100   000    Old_age   Always 
       -       0
189 High_Fly_Writes         0x003a   100   100   000    Old_age   Always 
       -       0
190 Airflow_Temperature_Cel 0x0022   067   061   045    Old_age   Always 
       -       33 (Lifetime Min/Max 30/33)
191 G-Sense_Error_Rate      0x0032   100   100   000    Old_age   Always 
       -       0
192 Power-Off_Retract_Count 0x0032   100   100   000    Old_age   Always 
       -       38
193 Load_Cycle_Count        0x0032   099   099   000    Old_age   Always 
       -       3397
194 Temperature_Celsius     0x0022   033   040   000    Old_age   Always 
       -       33 (0 16 0 0)
195 Hardware_ECC_Recovered  0x001a   055   053   000    Old_age   Always 
       -       141064238
197 Current_Pending_Sector  0x0012   100   100   000    Old_age   Always 
       -       0
198 Offline_Uncorrectable   0x0010   100   100   000    Old_age 
Offline      -       0
199 UDMA_CRC_Error_Count    0x003e   200   200   000    Old_age   Always 
       -       0

SMART Error Log Version: 1
No Errors Logged

SMART Self-test log structure revision number 1
No self-tests have been logged.  [To run self-tests, use: smartctl -t]


SMART Selective self-test log data structure revision number 1
  SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS
     1        0        0  Not_testing
     2        0        0  Not_testing
     3        0        0  Not_testing
     4        0        0  Not_testing
     5        0        0  Not_testing
Selective self-test flags (0x0):
   After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
--------------------------------------------------------------
dockstar ~ # lsusb
Bus 001 Device 003: ID 0bc2:2101 Seagate RSS LLC
--------------------------------------------------------------

Regards,

Alexander

PS: I also have a Fujitsu Siemens Storagebird Solo 20-U (250GB 2.5"),
USB Bus 002 Device 007: ID 04fc:0c15 Sunplus Technology Co., Ltd
which is identified by smartctl -d usbsunplus as an Western Digital 
Scorpio Blue Serial ATA family drive which already is in the smartctl 
database. Don't know if the USB-ID is of interest.

PPS: To be complete, the USB-ID of a Medion Drive-n-go (160GB 2.5") is 
04b4:6830 (-d usbcypress), the disk is identified as an Seagate Momentus 
5400.3 series, which is already in the DB too.

PPPS: Thanks that all those disks are now smart-enabled with 
smartmontools. ;)

------------------------------------------------------------------------------
Throughout its 18-year history, RSA Conference consistently attracts the
world's best and brightest in the field, creating opportunities for Conference
attendees to learn about information security's most important issues through
interactions with peers, luminaries and emerging and established companies.
http://p.sf.net/sfu/rsaconf-dev2dev
_______________________________________________
Smartmontools-database mailing list
Smartmontools-database@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/smartmontools-database

Reply via email to