Hi, I used to run 20160330T234717Z on two Dell R710 chassis without problems for years but since recently the fibre channel drivers were added to the smartos release I decided to upgrade. However networking does not work with the new version. Zero bytes are transferred in the link after kernel is booted while I just PXE booted from the same interface.
dladm show-phys shows the links just down: LINK MEDIA STATE SPEED DUPLEX DEVICE bnx0 Ethernet down 0 half bnx0 bnx1 Ethernet down 0 half bnx1 bnx2 Ethernet down 0 half bnx2 bnx3 Ethernet down 0 half bnx3 there is no config changes in-between, I just PXE boot boot_archive from release 20180203T031130Z, instead of 20160330T234717Z. After booting the older release networking again works without problems. I tried to force bnx0 to 1000/fdx but that had no effect. Any ideas? Sami ------------------------------------------- smartos-discuss Archives: https://www.listbox.com/member/archive/184463/=now RSS Feed: https://www.listbox.com/member/archive/rss/184463/25769125-55cfbc00 Modify Your Subscription: https://www.listbox.com/member/?member_id=25769125&id_secret=25769125-7688e9fb Powered by Listbox: http://www.listbox.com
