Well shoot. Thanks for the reply. Are there any plans to allow for this?
If not, one could consider this a feature request. :-) > -----Original Message----- > From: Tobias Oetiker [mailto:[EMAIL PROTECTED] > Sent: 2008, Tuesday, September 16 22:26 > To: Moe, Justin > Cc: [email protected] > Subject: Re: [smokeping-users] Adjusting probe times for one specific > target > > Hi Justin, > > at the moment smokeping runs on a single step size ... if you need > different checking intervals you have to run two copies. > > cheers > tobi > > > Yesterday Moe, Justin wrote: > > > Hello. > > > > Running smokeping 2.4.2 > > > > One of my targets needs to be checked more often than the others defined > > in the config file. Is this possible to set up? > > > > Example: > > > > My current entry for echopinghttp is: > > > > + EchoPingHttp > > forks = 5 > > offset = 50% > > step = 300 > > pings = 5 > > binary = /usr/bin/echoping > > extraopts = -R > > > > I attempted to set up a secondary probe to have a shorter step time: > > > > ++EchoPingHttpShort > > step = 100 > > > > But when I run --check, it errors with "probe EchoPingHttp missing from > > the Probes section" > > > > I get the same error with: > > > > ++ EchoPingHttpShort > > forks = 5 > > offset = 50% > > step = 100 > > pings = 5 > > binary = /usr/bin/echoping > > extraopts = -R > > > > If this is possible, can I get a hint as to what I'm doing wrong? > > > > Thanks! > > > > _______________________________________________ > > smokeping-users mailing list > > [email protected] > > https://lists.oetiker.ch/cgi-bin/listinfo/smokeping-users > > > > > > -- > Tobi Oetiker, OETIKER+PARTNER AG, Aarweg 15 CH-4600 Olten, Switzerland > http://it.oetiker.ch [EMAIL PROTECTED] ++41 62 775 9902 / sb: -9900 _______________________________________________ smokeping-users mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/smokeping-users
