Sorry for the misinformation about T-mobile USA - I just looked at http://en.wikipedia.org/wiki/T-Mobile_USA. As you point out the CDMA they use is just 3G.
On Feb 22, 5:10 pm, nxnlvz <[email protected]> wrote: > As long at the computer itself can service the interrupts and the > device has enough buffer to handle the high bit rate then a high rate > is fine. As with anything, it all comes down to what is waiting for > what. anything lower than 19.2 and the modem will always be waiting. > anything higher than 38.4 and the computer will be waiting. With a > CDMA modem, since they don't send messages the same way, a little > higher rate could be better. Maybe 38.4 and 57.6. This is a guess > though since I don't use the CDMA versions. > > At 115K rate though you should probably make sure you turn on either > soft or hard flow control since the cheaper serial modems have pretty > wimpy buffers in general. The higher end versions and USB versions > seem to be better in this regard. Again. This is an casual > observation and not a something I have specifically tested for. > > As Far as TMobile is concerned... where do they have CDMA? Unless you > mean the 3G variety I thought their entire network in Aorth America > was GSM. > > On Feb 22, 6:16 am, Alex <[email protected]> wrote: > > > > > Is there ever any disadvantage to using the highest baud rate > > available? > > > (T-mobile USA has CDMA as well; could be that using that?) > > > On Feb 20, 9:39 pm, Thanasis <[email protected]> wrote: > > > > 11 messages per minute??? > > > Is this on a pure GSM channel? No GPRS? > > > > On Feb 20, 6:48 pm,nxnlvz<[email protected]> wrote: > > > > > = 11.6 messages per minute -- You received this message because you are subscribed to the Google Groups "SMSLib User Group" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/smslib?hl=en.
