Hi Frank, Yes i am using same security name but if security name is similar then it will throw below error right ?
Message processing model 3 returned error: Unknown security name but i am getting MessageException: Message processing model 3 returned error: Unsupported security level I have done below changes by following one of the FAQ and it dint work either. please point me the FAQ you mentioned in previous email. USM usm = USMFactory.getInstance(); Regards Brijesh Date: Fri, 19 Dec 2014 10:01:37 +0100 From: [email protected] To: [email protected]; [email protected] Subject: Re: [SNMP4J] snmp4j for multiple device OK, then you hit an FAQ. As you are using the same security name for all the devices, it is essential (in other cases too, but you will not see the negative results that early) that you have a unique engine ID for each device. This is an absolut requirement by SNMPv3. Best regards, Frank Am 19.12.2014 09:47, schrieb Brijesh Kumar: Hi Frank, Thanks for your reply. My configurations are correct as i run multiple times and it worked some run and failed in other runs to be more specific device A, B,C worked first run and Device D and E failed. in second run Device A,E,C are successful . For some device privacy protocol was not applicable and some device it was set. > Date: Thu, 18 Dec 2014 20:45:35 +0100 > From: [email protected] > To: [email protected] > Subject: Re: [SNMP4J] snmp4j for multiple device > > Hi Brijesh, > > If you get an unsupportedSecurityLevel error, then you specified a > security level that is not supported > by your USM configuration. Basically, you will have to provide either a > privacy password and a > authentication password for the corresponding protocols in the > configuration. > > Best regards, > Frank > > Am 18.12.2014 18:10, schrieb Brijesh Kumar: > > Hi, > > I am running snmp4j request for 10 device parallel . I am using snmpv3 . If all devices is having same set of cred set it works fine. > > If any of this having different auth protocol (MD5 or SHA) or privacy protocol it fails . > > I am getting below error > > Message processing model 3 returned error: Unsupported security level > > > > Is there any way i can accomplish sending multiple snmpv3 request to different device parallely ? > > > > Regards > > Brijesh > > > > _______________________________________________ > > SNMP4J mailing list > > [email protected] > > https://oosnmp.net/mailman/listinfo/snmp4j > > -- > --- > AGENT++ > Maximilian-Kolbe-Str. 10 > 73257 Koengen, Germany > https://agentpp.com > Phone: +49 7024 8688230 > Fax: +49 7024 8688231 > > _______________________________________________ > SNMP4J mailing list > [email protected] > https://oosnmp.net/mailman/listinfo/snmp4j _______________________________________________ SNMP4J mailing list [email protected] https://oosnmp.net/mailman/listinfo/snmp4j
