Dan,
I use the same method on all my control linkages. If you do need to ever
change something later just hit the quick link with a little heat from a
soldering iron the CA will let go and you make your adjustments then CA it
again.
See Ya,
Pat McCleave
Wichita, KS
----- Original Message -----
From: "Dan Borer" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>; "rc Soaring Exchange" <[email protected]>
Sent: Monday, July 24, 2006 8:37 PM
Subject: Re: [RCSE] Numbered drill bit question
I use a 1/16" bit, followed by a drop of thin CA after the clevises and
control rod have been installed. I do each clevis at the end of the control
rod individually, let it cure, cycle the surface through its range of
movement and then do the same to the opposite end. If using a threaded rod
I will then put a drop of thin CA on the threads where they enter the
clevis once I am satisfied with the setup. This all sounds too permanent
but works well and still allows disassembly when necessary.
Dan
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: "rc Soaring Exchange" <[email protected]>
Sent: Monday, July 24, 2006 5:59 PM
Subject: [RCSE] Numbered drill bit question
I want to minimize slop in my control surfaces.
What numbered drill bit, or bits, do I need for drilling out control
horns and servo arms for Dubro type quick links?
Thanks,
RCSE-List facilities provided by Model Airplane News. Send "subscribe"
and "unsubscribe" requests to [EMAIL PROTECTED] Please note
that subscribe and unsubscribe messages must be sent in text only format
with MIME turned off. Email sent from web based email such as Hotmail
and AOL are generally NOT in text format
RCSE-List facilities provided by Model Airplane News. Send "subscribe"
and "unsubscribe" requests to [EMAIL PROTECTED] Please note
that subscribe and unsubscribe messages must be sent in text only format
with MIME turned off. Email sent from web based email such as Hotmail and
AOL are generally NOT in text format
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe
messages must be sent in text only format with MIME turned off. Email sent from web based email
such as Hotmail and AOL are generally NOT in text format
