Looking through my copies of plans and instructions for the Cirrus, the CG should be 3 5/64" to 3 35/64"aft of the leading edge. I have always figured this was measured close to the root of the wing. I see no mention of control throws anywhere. The instructions it seems assume you are using Graupner radio gear of the day and possibly the throws are built in to the setup. I have usually used 3/4" to each side from cemter on rudder and stabilizer as a good starting point. Hope this helps, Mark --- Dave Haskins <[EMAIL PROTECTED]> wrote: > Does any one have the CG and control surface throws > for a > Graupner Cirrus? A friend purchased one at a swap > meet and did not > get a manual for it. If any one could help we would > really > appreciate it. > > Thanks > Dave H. > > __________________________________________________ Do You Yahoo!? Get personalized email addresses from Yahoo! Mail http://personal.mail.yahoo.com/ RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]
