> This is speculation, cause I've never tried it, but perhaps a rotary
cutter would work,
> especially with the masking tape that has already been suggested.  What is
a rotary
> cutter?  It looks like a high-tech pizza cutting wheel and you use it
pretty much the same
> way.  The usual application is cutting fabric for clothes, quilts and
such.  Mostly they
> seem to be useful for straight cuts and moderate curves.  Might be
difficult for tighter
> curves or inside corners.  A rotary cutter is always used on a cutting mat
which is a
> plastic sheet with a moderately hard surface.  The cutter wheel cuts
through the fabric,
> and slightly into the pad.  Cutting slightly into the pad insures that the
fabric fibers
> are cut through, but the pad protects your table top and provides a
consistant surface for
> the rotary cutter that does not damage the cutting wheel.  You can buy the
rotary cutter,
> replacement blades and cutting pad at a fabric store.  Ask when they will
be on sale,
> cause the list prices seem a bit high to me.

Mark,
In order to be successful in cutting kevlar with a rotary cutter, the
'moderately hard cutting surface' must be extremely hard. Using a moderately
hard surface such as a 'self-healing' matt to cut kevlar only results in the
kevlar fibers being forced into the cutting matt and not being cut. By the
time you have a hard enough surface, the rotary cutter would rapidly be
destroyed and it is highly unlikely that the kevlar would be cut.

The best way to cut kevlar is with a shears that has a serated edge.
Anything else will yield a less than satisfactory result. I believe that
both Aerospace Composites and Composite Structures sells them.

Regards,
Bob Johnson
Fond du Lac, WI


RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to