I originally tried cutting Kevlar with the masking tape trick, but found that removing the masking tape from the cut piece would fray the edges producing a 'not clean' finished piece.
A much better way to cut Kevlar is to take an old pair of scissors and file a pretty flat angle into them.
Normally, scissors have a rather steep angle on each blade. This is great for cutting most materials, but really causes a problem when cutting Kevlar. The thing to do is to file each blade of the scissors almost flat. Don't worry about getting them smooth, as a rougher surface seems to help.
The flatter angle of the scissors will now 'grip' and hold the Kevlar while it is being cut.
Can't take credit for this one, got the idea from Denny Maize at PoleCat Aero Plane Works.
Jeff Winder
Cincinnati, OH
-----Original Message-----
From: Bob Johnson [SMTP:[EMAIL PROTECTED]]
Sent: Thursday, January 10, 2002 9:41 AM
To: Mark D. Holm; [EMAIL PROTECTED]
Subject: Re: [RCSE] Kevlar cutting
> This is speculation, cause I've never tried it, but perhaps a rotary
cutter would work,
> especially with the masking tape that has already been suggested. What is
a rotary
> cutter? It looks like a high-tech pizza cutting wheel and you use it
pretty much the same
> way. The usual application is cutting fabric for clothes, quilts and
such. Mostly they
> seem to be useful for straight cuts and moderate curves. Might be
difficult for tighter
> curves or inside corners. A rotary cutter is always used on a cutting mat
which is a
> plastic sheet with a moderately hard surface. The cutter wheel cuts
through the fabric,
> and slightly into the pad. Cutting slightly into the pad insures that the
fabric fibers
> are cut through, but the pad protects your table top and provides a
consistant surface for
> the rotary cutter that does not damage the cutting wheel. You can buy the
rotary cutter,
> replacement blades and cutting pad at a fabric store. Ask when they will
be on sale,
> cause the list prices seem a bit high to me.
Mark,
In order to be successful in cutting kevlar with a rotary cutter, the
'moderately hard cutting surface' must be extremely hard. Using a moderately
hard surface such as a 'self-healing' matt to cut kevlar only results in the
kevlar fibers being forced into the cutting matt and not being cut. By the
time you have a hard enough surface, the rotary cutter would rapidly be
destroyed and it is highly unlikely that the kevlar would be cut.
The best way to cut kevlar is with a shears that has a serated edge.
Anything else will yield a less than satisfactory result. I believe that
both Aerospace Composites and Composite Structures sells them.
Regards,
Bob Johnson
Fond du Lac, WI
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]

