Joedy, To clarify what Tony is saying, you can make up servo wiring by taking individual "wires" and twisting them together. Each "wire" should be made up of many small copper strands surrounding by an insulating jacket. You can get "solid" wire which is a single piece of copper surrounded by an insulating jacket. This type of wire tends to fatigue and break more easily than multi-strand wire. That is why the wiring on all of your household widgets is multi-strand.
Once you twist the three "wires" together, go over wiring with a heat gun. This will soften the insulation and "set" the twist in the wires. Dick =============== >Use single strand and wind it w/ your electric drill. It'll be cheaper and >you get increased EMI noise rejection for free. > >--TR >Portland, OR > > >-----Original Message----- >From: Joedy Drulia [mailto:[EMAIL PROTECTED]] > >Can anyone point me to a source of the typical 3 conductor servo wiring in >22 ga? > >I have found a local source for the 26 ga variety, but not the 22 ga. >RCSE-List facilities provided by Model Airplane News. Send >"subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] -- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Dr. Richard C. Williamson Phone: 781-981-7857 Room C-317 FAX: 781-981-0122 Lincoln Laboratory Email: [EMAIL PROTECTED] Massachusetts Institute of Technology 244 Wood Street Lexington, MA 02420-9108 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]
