Ed Berris wrote: > Andrew, I'm not sure if I'm understanding your "mixing water". What you > should be doing for best results in misting foam wing cores with a spray > bottle. I hold the bottle about 24" from the surface so just a fine mist > falls on the wing cores. If you are actually mixing water with the ProBond > that's probably why you are not satisfied with the results.
Misting doesn't work well enough in my experience. The water that is on the surface of the foam helps, but any that falls into a cell (where expansion is needed most) doesn't get contact with any Probond until it is too late (Probond almost set). Pre-mixing a bit of water with Probond _and_ misting foam works very well. I was not satisfied when _not_ using any water, or in general wood construction as Probond is so low tack and slow to set. -- Andrew E. Mileski Ottawa, Canada RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]
