Yes I have, and I sent my response to the list. It is also very clear in the manual except for a few steps that tell you how to actually mix the motor channel with the moto hold function. Here it is again� You first have to go to device select in the system mode. Activate �MOTO� at bottom of screen, (use the scrolling wheel to highlight �act/inh�)then click. Then scroll back to �moto� click, then scroll to the one of 9 switches, buttons, sliders, or sticks, then click again, exit, done.. Check out the following for more on electric motor set up. This article gives a step by step guide to using the moto hold function and flight modes.
http://www.scalesoaring.net/EMM/9303.htm JD Endless Mountain Models http://www.scalesoaring.com email: [EMAIL PROTECTED] Endless Mountain Models http://www.scalesoaring.com email: [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Sent: Saturday, October 16, 2004 6:10 PM To: [EMAIL PROTECTED] Subject: [RCSE] 9303 with an electric Recently I asked�if anyone had a chance to actuate�an electric motor using a switch with the XP9303. I asked if anyone has done it, not if someone had read the manual. For those of you that read the manual, as I have, you might hane been under the impression that there was a way to assign the MOTO function to a switch. � If anyone has actually�set up�the 9303 with an electric 6-servo plane, I'd like to know what solution you came up with. I have one already, but there may be a more elegant solution that I am not aware of. � - Steve RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe messages must be sent in text only format with MIME turned off.
