My older Berg 6 channel receivers had a soldered "jumper" to select either channel 7 or channel 5 as the channel 5 output. To switch from channel 7 to channel 5 simply unsolder from the channel 7 side and resolder to the channel 5 side. The actual "jumper" is a "zero ohm" surface mount resister. The actual part is rather small, you might want someone with proficiency in soldering to do the work for you.
As a side note, in order to use channels 2 through 7 from your JR 783, 8103, etc, Leave output 5 connected to either channel 5 or 7, cut the actual signal pin to output 1 and solder a small wire from the unattached channel 7 or channel 5 to the channel 1 output pin. Then, if channel 7 is routed to output 5 then, with channel 5 routed to output 1, the available channels become: TX RX 1 - 2 2 Right Aileron 3 3 Elevator or Left vtail 4 4 Rudder or Right vtail 5 1 Left Ailereon 6 6 Left Flap 7 5 Right Flap 8 - or if channel 5 is already routed to output 5 then, with channel 7 routed to output 1, the assignments are: TX RX 1 - 2 2 Right Aileron 3 3 Elevator - Left vtail 4 4 Rudder - Right vtail 5 5 Left Ailereon 6 6 Left Flap 7 1 Right Flap 8 - This allows use of Berg 6 on full house sailplanes. Of course, the JR 9303 takes care of this in glider mode by reassigning the left aileron to channel 1 and the right flap to channel 5 ... giving the same functionality as the first example above, only without the channel changing at the receiver. With a little thought, it works for me. Also, the older Bergs had another "zero ohm" jumper for shift select. Thus the receivers were quite versatile. Jerry Millett --- In [EMAIL PROTECTED], "ghmenut" <[EMAIL PROTECTED]> wrote: > > I solved the riddle, so here it is: > > The problem: Berg 6 Rx channel 5 correspond to JR ch 7 (Aux 2) - not > Ch 5 (L Ail) > How do you set up a Flaperon glider when there is no ch 5? > > The solution: Use GLID module, Dual Flap ACT > Ail to Flap Mix 100% Switch ON > For camber and spoileron landing, use Butterfly mixes, but enter the > same values for SPOI->AILE (R flaperon) > and SPOI->FLAP (L spoileron) > > > > RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe messages must be sent in text only format with MIME turned off. RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe messages must be sent in text only format with MIME turned off.
