Sorry for top post, stuck on outlook right now.
Did you change the baud rate to either Soekris or OpenBSD? Soekris defaults to 19.2k and OpenBSD defaults to 9600. During install OpenBSD asks if you want to redirect console to com1, and also Lets you set the speed here. You can change this is /etc/boot.conf Mike From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Vincent Li Sent: Wednesday, September 19, 2007 8:41 AM To: [email protected] Subject: [Soekris] openbsd won't boot from net4801 after pxe installation Hello all, This is my CF info from comBios: ---- Pri Mas SanDisk SDCFB-2048 LBA Xlt 992-64-63 2001 Mbyte --- After I partitionize the CF, I got following message: ------ pciide0:0:0: bus-master DMA error: missing interrupt, status=0x20 wd0: transfer error, downgrading to PIO mode 4 wd0:(pciide0:0:0): using PIO mode 4 wd0a: device timeout writing fsbn 96 of 96-0 (wd0 bn 159; cn 0 tn 2 sn 33), retrying wd0: soft error (corrected) ------- Then the installation continues and succeed: ---- Making all device nodes...done... ....blah,blah... CONTRATULATIONS!Your OpenBSD install has been successfully completed! ..... reset the machine and boot from the disk ----- Then I typed reboot at prompt, it reboot and hangs here: ------- boot> booting hd0a:/bsd:5567348+871228 [52+283664+263996]=0x6a9ba4 entry point at 0x200120 --------- does this mean that the bootloader boot OpenBSD from address 0x200120 and could not find the boot partition? do I have a faulty CF because of "pciide0:0:0: bus-master DMA error: missing interrupt, status=0x20"? Thanks
_______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
